Additional safety instructions, Additional safety instructions for grinders, Always wear eye protection – Black & Decker 6112 User Manual
Page 5: Keep guards in place, Save these instructions, Motor, Switch, Auxiliary handle, Tool operation, Save these instructions motor
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADDITIONAL SAFETY INSTRUCTIONS
Additional Safety Instructions for Grinders
•
ALWAYS WEAR EYE PROTECTION.
•
KEEP GUARDS IN PLACE.
•
Use only grinding wheels having a maximum operating speed at least high
as “No Load RPM” marked on the tool’s nameplate.
•
Before using, inspect recommended accessory for cracks or flaws. If such a
crack or flaw is evident, discard the accessory. The accessory should also
be inspected whenever you think the tool may have been dropped.
•
When starting the tool (with a new or replacement wheel installed) hold the
tool in a well protected area and let it run for one minute. If the wheel has an
undetected crack or flaw, it should burst in less than one minute. Never start
the tool with a person in line with the wheel. This includes the operator.
•
In operation, avoid bouncing the wheel or giving it rough treatment. If this
occurs, stop the tool and inspect the wheel.
•
ALWAYS USE GUARDS
with depressed center wheels or flaring cup grind
ing wheels.
•
Clean your tool out periodically.
•
CAUTION:
Some wood contains preservatives such as copper chromium
arsenate (CCA) which can be toxic. When sanding these materials extra care
should be taken to avoid inhalation and minimize skin contact.
SAVE THESE INSTRUCTIONS
Motor
Your B&D tool is powered by a B&D built motor. Be sure your power supply
agrees with the nameplate marking. Voltage decrease of more than 10% will
cause loss of power and overheating. All B&D tools are factory tested; if this
tool does not operate, check the power supply.
TOOL OPERATION
Switch
To start the tool, squeeze the trigger switch shown in Figure 1. To turn the tool
off, release the switch.The tool can be locked on for continuous use by holding
the trigger switch depressed while you depress the switch locking button next
to the trigger, shown in Figure 1. Hold the locking button in as you gently
release the trigger. Release the locking button and the tool will continue to run.
To turn the tool off from a locked on condition, squeeze and release the trigger
once.
Auxiliary Handle
An auxiliary handle is provided with your tool for convenience. The handle can
be screwed into either side of the gear case, shown in Figure 2, and should be
used at all times when sanding or grinding.
Figure 1
Figure 2
AUXILIARY HANDLE