Bolens 140-990A - Manual (Page 10)

-f-
\t ■'
f : -
”i< ■ .‘•^-'■V'-íí“'-'!
‘4
' i
FIGURE 11. FIGUREIS.
Power Take Off Operation (PTO)
There are two PTO’s on your tractor. The front PTO
is a pulley located behind the grille and is used to
operate the snow thrower. This PTO is directly
connected to the engine and operates whenever
the engine is running.
The rear PTO is located under the tractor and is
used to operate the grass cutting deck and rotary
tiller. (See figure 12.)
H-:;- '
■t.
Power Take Off
(PTO)
The rear PTO is operated by the PTO lever. (See
figure 13.)
■^NOTE
The PTO lever must be in the
DISENGAGED position to start the
engine.
High/Low Axle Range
Your tractor is equipped with a two speed rear ax­
le for greater versatility. (See figure 14.) The LOW
range is used when operating the rotary tiller,
moldboard plow and should also be used when ex­
tra power is required.
HIGH range operation is for normal loads, grass
cutting and normal use.
LOW Range (0-4 mph)
HIGH Range (0-8 mph)
The Axle Range Lever must be in either the HIGH
or LOW range position. The tractor will not move if
it is in the center position.
FIGURE 12.
NOTE
When pushing the tractor by hand
with the engine shut off, place the
Axle Range Lever between the
HIGH and LOW position. The hydro­
static pump will not rotate and the
tractor will be easier to push.
10