Bolens 140-990A - Manual (Page 14)

Rykon Industrial Oil #31
Amoco 300, 20 wt.
Rotella, 20 wt.
Rimula Series 3, 20 wt.
X100 Motor Oil, 20 wt.
Havoline Motor Oil, 20 wt.
Ursa, Extra Heavy, 20 wt.
NOTE
If the above oils cannot be obtained,
SAE 20 motor oil with a SE rating
may be substituted.
FIGURE 23.
The capacity of the unit is 5 quarts. However,
because the oil will not completely drain from the
lift system and hydrostatic transmission, you will
only drain approximately 3 quarts. To drain,
remove the plug from the bottom of the transaxle.
(See figure 24.)
6
.
Oil Filter
(See figure 25.) A full flow replaceable oil
filter, located under the left side of the frame,
should be replaced initially after twenty hours
of operation and thereafter every 100 hours for
commercial or industrial applications and
yearly for normal usage. It can be removed by
turning it counterclockwise by hand. Use
Fram filter PH-16 or equivalent.
FIGURE 25.
7. Hydrostatic Control—Lubricate between the
control slide and the control adjustment plate.
(See figure 35.)
Disc Brake Adjustment
k'-
Disc Brake
■ A
Disc
FIGURE 24. FIGURE 26.
14