Assembly, Note, Contents of hardware pack (see figure 1.) – Bolens 140-990A User Manual
Page 5: Hex lock-htrt (f) v2" w jiich, Steerlnr/mie, Attaching steering wheel, Attaching the seat
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FIGURE 1.
ASSEMBLY
The Garden Tractor is packed and shipped in one
container and is fully assembled except for the
steering wheel, seat, battery and mounting the
three point hitch.
NOTE
Reference to left or right side
of machine is from the operator’s
position in the seat facing forward.
-Contents of Hardware Pack
(See figure 1.)
A (1) Battery Hold Down
B (2) Battery Hold Down Rods
C (2) Fiat Washers
D (2) Wing Nuts
E (1) Steering Wheel Cap
F (1) Hex Lock Nut 5/16-18Thread
G (1) Belleville (Curved) Washer
H (1) Hex Bolt 1/2-13x1.00" Long
I (1) Lock Washer
1
/
2
" I.D.
Hex Lock-Htrt (F)__ V
2
" W jiich
Belleville
Steerlnr/mie
ATTACHING STEERING WHEEL
1. Place the steering wheel over the steerng
column extending through the dash. Line up
the flats on the steering column with the flats
------in the steering wheel. (See figure 2.)
2. Place the belleville (curved) washer (G) with
the cupped side down over the steering col
umn and secure with hex lock nut (F).
3. Place the steering wheel cap (E) over the
center of the steering wheel and seat it with
your hand.
FIGURE 2.
ATTACHING THE SEAT
Select one of four seat positions on the tractor
-seat spring. Secure seat to seat spring with hex
bolt (H) and lock washer (I). (See figure 3.)