Fcc compliance, Declaration of conformity, Canada emi regulation – Cisco Explorer 8300 User Manual
Page 19: Trademarks, Disclaimer, Software and firmware use notice
Explorer 8300 Digital Video Recorder
Scientifi c-Atlanta, Inc.;
5030 Sugarloaf Parkway;
Lawrenceville, Georgia 30044; USA
This device has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
such interference in a residential installation.
This equipment generates, uses, and can radiate
radio frequency energy. If not installed and used
in accordance with the instructions, it may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the cable company or an experienced
radio/television technician for help.
Any changes or modifi cations not expressly
approved by Scientifi c-Atlanta, Inc., could void the
user’s authority to operate the equipment.
The information shown in the FCC Declaration of
Conformity paragraph below is a requirement of the
FCC and is intended to supply you with information
regarding the FCC approval of this device. The
phone numbers listed are for FCC-related questions
only and not intended for questions regarding the
connection or operation for this device. Please
contact your cable service provider for any questions
you may have regarding the operation or installation
of this device.
Declaration of Conformity
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
1) the device may not cause harmful interference,
and 2) the device must accept any interference
received, including interference that may cause
Canada EMI Regulation
This Class B digital apparatus complies with
Cet appareil numérique de la class B est conforme à
la norme NMB-003 du Canada.
20060628 FCC Standard
Cisco, Cisco Systems, the Cisco logo, the Cisco
Systems logo, Scientifi c Atlanta, the Scientifi c Atlanta
logo, Explorer, and Multi-Room are registered
trademarks or trademarks of Cisco Systems, Inc.
and/or its affi liates in the United States and certain
Cisco Systems, Inc. assumes no responsibility for
errors or omissions that may appear in this guide.
We reserve the right to change this guide at any time
Software and Firmware Use Notice
The software described in this document is protected
by copyright law and furnished to you under a
license agreement. You may only use or copy this
software in accordance with the terms of your license
The fi rmware in this equipment is protected by
copyright law. You may only use the fi rmware in the
equipment in which it is provided. Any reproduction
or distribution of this fi rmware, or any portion of it,
without our express written consent is prohibited.