Amerec PKLE 2024 - Manual (Page 3)

4 .
If the wall ha$ been bedded in. a 2 inches vent hole
between the wall and the vertical surfaces of the
stove is enough. (Figure 4)
Figure 4
Dimension A is ooterminoa accordlna to ih*
proraclwn maUiod u»od for woûdan aurfaceB
" KOtncTte^wilH no protottSfiD
-10 incJies \Mth aing/o sheet metoi ptioioction
- 5 ïnçh» vriiii double Sheet mow protioUon
5. A SSmm embedding with Open sides at a minimum
30mm distance away from the protected surface is
equivalent
for a single light protection. Likewise,
a 110mm embedding not touching the protected
surface would be equivalent for a double light
protection. (Figure 5)
Protectingtho ceiling:
Provided the distance between the stove top and the
ceiling is minimum 1200mm. no special protection is
needed for the ceiling. If the distance is less than 1200mm,
you can choose one of the protection methods mentioned
in items 1-3, The ceiling protection must extend above the
vertical surfaces of the stove. (Figure 6)
Figure 5
Figure 6
........ - " --- -------------
F mm
No oroioction for the
1200
F ceiling
Sinijle l)0ht
000
pfoteciion
FIREPLACE BASE
The fireplace must be installed on a rigid base. This base must be strong enough to bear the
weight of the fireplace and to prevent any excessive rise of temperature of the structura!
elements connected to it When Installing the stove on a wooden floor, It is advisable to use a
minimum 50mm thick concrete stab or a minimum 7mm thick fiber-reinforced cement plate
covered by a metal plate.
Protectioff the floor In front of the stove
The safety distances listed in items 1-6 cannot be applied
to a combustible floor area in front of the stove. This area
should be protected using a metal plate connected to the
floor and closely fitting the stove. The floor protection in
frontofthestovemustextendatleast to 100mm beyond
both side of the overt mouth and to 400mm in front of it
3