Amerec PKLE 2024 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

iNSTAtLiNG THE STOVE

As in all our stoves, th^re Is

an escape

hole for the smoke flue on top of the

stove as well as behind it. You cian close the unnecessary hole using the

closing trap supplied. Included with the delivery, you Witi also receive

a

200mm connecting pipe for connecting the stove to the smoke flue through

the back hole. When connecting the stove to the smoke flue through the
hole on top of the stove, we recommend you use our connecting pipes which

are avaiiabie as accessories. When doing this, do not forget to dose the

smoke hole behind the stove using the closing trap supplied, (Figure 6)

Do not install the connecting pipe too deep i nto the smoke flue, because

this would block the draught The gap between the smoke flue and the
connecting pipe must be filled using e g, mineral wool.

When installing the stove, make sura the stove stands firmly on Its base and
the

proper

safety

distances

mentioned

in

these

instructions

have

been

observed

Figure 8

PREHeATlNG

In the factory, the interior parts of the stove have been coated with protective agents to prevent

corrosion during storage. Before starting to use the stove and placing rocks on the stove, you
should preheat the stove in order to remove these protective agents. It is enough to burn 1-2

ovenfulis of wood for preheating. During preheating, sufficient ventilation should be arranged in

the washroom to dissipate the smoke gases producad by the protective agents.

STOVE ROCKS

Always use rocks supplied by the manufacturer in your stove

Before placing the rocks onto the stove, carefully wash them with dean water. Do not use any

detergents.

Place the rocks on top of each other so that they are level with the edge of the rock well. Be

careful not to place the rocks too dose to each other to allow air circulation between the rocks.
Place the largest rocks at the bottom of the rock well.

HEATiNG UP THE STOVE

Only wood can be used for heating up the stove. Before healing, the stove grate should always

be cleaned and the ash pan emptied

Avoid heating the siove so that the passage in the rock well remains red heated for a tong time

beacause this would overload the firebox and shorten the lifetime of the stove.

After your saunabath, you can leave a small fire In the stove to dry up the washroom constructions,

STOVE MAINTENANCE

The stove must be swap through the soot hatches at least once a year in order to maintain optimal
draught- At the same lime, it is also useful to check the condition of the stove rocks and to replace

the decayed ones by new ones

Advertising
This manual is related to the following products: