Autostart Two-way 6-Button LCD Automatic Transmission Remote Starter User - Manual (Page 5)

Unlock 2 beeps
Start Melody
Stop None Melody
Trunk 1 Beep
Start/Stop While in Safe Start Mode
Function Button press Icon Sound Description
Start on safe start
mode
li.Ka Melody
Press ^
simultaneously twice within 3
seconds. Press for 1 sec- a beep
will be heard- then press 1 sec
and a melody will be heard
again.
Stop on safe start
mode
None Melody
Missing a Start or a Stop Confirmation
If you have not received a Start or the Stop confirmation after pressing the ~ button, simply press
the button. Pressing the button will refresh the display and will confirm if the vehicle was
started or stopped.
No Start Confirmation Was Received:
If after remote starting the vehicle no confirmation was received, simply press the button, this
will refresh the display. If the vehicle was started successfully, the smoke icon and the hourglass
icon will appear as well as the run time countdown. Pressing the ! button will also lock all doors
(the lock icon will appear). If the doors were already locked prior to pressing the ^3 button, there
will be no change in the status of the doors—i.e. the doors will remain locked.
On models where starter kills were installed, pressing the I
kill.
1 button will also activate the starter
No Stop Confirmation Was Received:
If after remote stopping the vehicle no confirmation was received —i.e. the display did not return to
its basic state— simply press the ^3 button, this will refresh the display. If the engine was
stopped, the smoke icon and the hourglass icon will disappear and the time will be displayed.
Pressing the HH button will also lock all doors (the lock icon will appear). If the doors were already
locked prior to pressing the SH button, there will be no change in the status of the doors -
doors will remain locked.
i.e. the
On models where starter kills were installed, pressing the I
kill.
! button will also activate the starter
P. 12 User Guide
c. To save modifications , do not touch any buttons
for approx 5 to 10 seconds. There wiii be a beep
Pressing the
JEl
button
1X................................. Adjust minutes (current time)
2X..................................................Adjust hour (Alarm)
3X............................................. Adjust minutes (Alarm)
4X.............Melody selection for the ringing of the alarm
and the display will return to the time.
5X............. Activate (ON) / Deactivate (OFF) Alarm
6X................................... Adjust hour (countdown)
7X.............................. Adjust minutes (countdown)
8X................... Melody selection for the countdown
9X.....Activate (ON) / Deactivate (OFF) countdown
Timing Countdown Adjustment
(see “ON PRESS NUMBER” 8 of Alarm and Countdown Adjustment)
Function By pressing Icon Sound Instructions / description
FOR PARKING
COUNTDOWN
1st time B U' tu Melody
10 min parking count down
mode
IB + ^ 2"'^ time a u'Cw
Melody
20 min parking count down
mode
[S-p ^3'''^time
ry- jn
i:
Melody
30 min parking count down
mode
[S + ^4»h time
i.rtrk
f i-tJV Melody
60 min parking count down
mode
IB + ^ 5'*^ time
rOO
a f< jfu
Melody
90 min parking count down
mode
IB + ^ 6'*^ time
1 C'uu Melody
120 min parking count down
mode
IB + ^ 7'*^ time 1 u~uu Melody
Parking count down off
mode
Once the Countdown is activated it will continue counting down until reaching 0:00. If the Timer has not
reached 0:00 and you are starting the vehicle, you should reset your Countdown Timer to 0:00 before starting
your vehicle as to avoid being startled.
Remote-Starting Your Vehicle
Remote starting
Press the ^ button for approx. 1 second. The parking lights will come o n to inform you that the
remote starter has received your signal. Approximately 5 seconds later, the engine will start. The
parking lights will remain o n during the pre-programmed run time of the engine. If the vehicle does
not start at the first attempt, the system will shut down, wait a few seconds and try to start the
engine again. There will be 3 start attempts before the system gives up.
Driving Off
With the vehicle running under remote control, press the S button to disarm and unlock the
doors. Enter the vehicle and do the following:
Turn the ignition key to the
ignition o n ( run ) position. (Do not turn the key to the crank position
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Arming the Starter Kill
The starter kill (if installed) can be configured by the installer so as to arm automatically (passive
mode) or not to arm automatically (active mode).
! button on the transmitter. To disarm the starter kill, press the (
The parking lights will flash twice.
If remote door locks are installed, this will also unlock the doors.
To arm the Starter Kill, press the S button on the transmitter.
User Guide P. 5