Graphic equalizer, Press one of the graphic equalizer buttons, To cancel the selected mode – Aiwa CX-NA22 User Manual
Page 7: To select with the remote control, To search for a station quickly (auto search), When an fm stereo broadcast contains noise, To change the am tuning intervai, Graphic equalizer manual tuning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GRAPHIC EQUALIZER
MANUAL TUNING
I
MONO
TUNER
S
§o
ÚL
lU
oíá
So
<Q
Q.<
UJ
q
;
CC
Q.
This unit provides the following three different equalization curves.
ROCK: Powerful sound emphasizing treble and bass
POP: More presence in the vocals and midrange
JAZZ: Accented lower frequencies for jazz-type music.
Press one of the GRAPHIC EQUALIZER buttons.
To cancel the selected mode
Press the selected button again. “EQ oFF” is displayed.
To select with the remote control
Press the GEQ button repeatedly while pressing the SFIIFT
button.The GEQ mode is displayed cyclically as follows.
C
ROCK-
POP-
JAZZ
EQoFF —I
(cancel)__ ^
1 Press the TUNER/BAND button repeatedly to
select the desired band.
FM-
AM
When the TUNER/BAND button is pressed while the power
is off, the power is turned on directly.
To select a band with the remote control
Press the BAND button while pressing the SHIFT button.
Press the ◄◄ DOWN or ►► UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, (ncffiil) is displayed.
TUNE
11IC®))I
I
< i
To search for a station quickly (Auto Search)
Keep the ◄◄ DOWN or ►► UP button pressed until the tuner
starts searching for a station. After tuning in to a station, the
search stops.
To stop the Auto Search manually, press the ◄◄ DOWN or ►►
UP button.
• The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button while pressing the SHIFT button
on the remote control so that “AUTO” disappears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press these buttons so that “AUTO”
appears.
To change the AM tuning intervai
The default setting of the AM tuning iriterval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
ENGLISH
6