Aiphone MYW-BA - Manual (Page 6)

SPECIFICATIONS
Power source
Current consumption
Cable requirements
MYW-BA; DC 18V. Can be powered by a PS-18D (PS-18C in North America) of using
PanTilt monitor system. Replaces PS-18YD/A (PS-18YC/A) in MY-ICD system.
250mA. ImA(standby)
Use specified cable to each PanTilt door station and Monitor station /video adaptor.
* Impedance ; 90 ohm
* Permitted closed loop DC resistance : 9.9 ohm or less
* Insulation must not be PVC
In USA, cable type West Penn D990 or equivalent.
Wiring Total 6 conductors run from MYW-BA to video trunkage line.
2 conductors to PanTilt door station and 2 to using main monitor MY-1 CD, MY-2CD or
MY-CU in TD-(6, 12, 24) H system. In LEF-(5, 10, 10S), the same 2 conductors to MYW-P (1,3) L video adaptor.
The rest 2 conductors go to the system’s power supply PS-18D (18C) or Its own.
Wiring Distance MYW-BA to PanTilt door (with specified cable)
Diameter 1.0mm 1.2mm AWG 18AWG 16AWG
Distance 200m 300m Distance 650’ 980’
MYW-BA to video-monitor (main) or MYW-P(1,3)L
Diameter 1.0 or 1.2mm AWG 18or16AWG
Distance 50m Distance 165’
MYW-BA to power supply
Diameter 1.0mm 1.2mm AWG 18AWG 16AWG
Distance 7m 10m Distance 23’ 33’
Dimensions (H x W x D)
Weight
190 mm X 80 mm x 42 mm. 7-1/2" x 3" x 1-5/8"
Approx. 210 g {0.46 lbs.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residentiai installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. • Increase the separation between the equipment and receiver. • Consult the dealer or an experienced radio/TV technician
for help.
Aiphone warrants its products to be free from defects of material and workmanship under normal use and servioe for a
period of two years after delivery to the ultimate user and will repair free of charge or replace at no charge, should it
become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto itself
the sole right to make the final decision whether there is a defect in materials and/or workmanship; and whether or not the
product is within the warranty.
This warranty shall not apply to any Aiphone product which has been subject to misuse, neglect, accident, or to use in
violation of instructions furnished, nor extended to units which have been repaired or altered outside of the factory. This
warranty does not cover batteries or damage caused by batteries used in connection with the product.
This warranty covers bench repairs only, and any repairs must be made at the shop or place designated in writing by
Aiphone.
Aiphone will not be responsible for any costs incurred involving on site service calls.
•F
•F
•F
Ф
•F
•F
•F
-F
•F
•F
•F
•F
►F
•F
•F
-F
•F
•F
Aiphone Co., Ltd., Nagoya, Japan
Aiphone Corporation, Bellevue, WA, USA
W1YW-BA-I(E)0496G
© COMMUNICATION SYSTEMS
AIPHONE
HOME, BUSINESS, INDUSTRY.
Printed in Japan (E)