Directed Electronics VIPER 5701 - Manual (Page 16)

© 2008 Directed Electronics—all rights reserved 0
System maintenance
The system requires no specific maintenance. Your remotes are pow-
ered by small coin cell lightweight 3-volt lithium batteries that will
last approximately one year under normal use. The 2-way remote
uses two CR2016 cell batteries and the 1-way remote uses one
CR2032 cell battery. When the battery begins to weaken, the oper-
ating range will be reduced.
Low battery indicator
When the batteries are low on the 2-way remote it will emit two
groups of beeps, the LED will flash, and the alarm will emit an
additional chirp to let you know its time to change the battery.
When the battery is low on the 1-way remote, the remote responds
the same, but without the LED flash.
Note: The Arm/Disarm chirps should be programmed ON for the
alarm to emit any additional chirps during disarm. Ask your
authorized dealer if you have any questions.
Battery Replacement
Slide the door up to expose the battery beneath the holder. Remove
the expired battery. Place the new battery into the remote control.
When power is returned the remote control is ready for use.