Directed Electronics VIPER 5701 - Manual (Page 38)

© 2008 Directed Electronics—all rights reserved 
controls on.
To perform Valet take-over:
Before turning off the engine, press and release within 3 sec-
onds on the transmitter. Then wait a few seconds.
Turn the ignition key to the OFF position (The engine will stay
running).
The engine will run until the pre-programmed time elapses or a
shut-down input is received.
Note: To enable Valet take-over with a manual transmission, open the
door when going into a manual transmission mode. After you exit the
vehicle you can arm the alarm and the car will remain running. If the
vehicle shuts down when arming, then the unit did not enter the valet
take-over mode.
1.
2.
3.