Desa Remington 100271-01 - Manual (Page 9)

102891
OWNER’S MANUAL
7
Figure 3 - Assembling Guide Bar, Chain, and Hand Guard
Adjusting
Block
Adjusting
Screw
Sprocket
Support
Adjusting
Plate
Figure 4 - Part Locations for Assembling Guide Bar
Drive
Sprocket
Guide Bar
Bolts
Saw
Chain
Guide
Bar
Adjusting Hole
Guide Bar
Nuts
Cutting
Edge
Towards
Guide
Bar Nose
Sprocket
Support
ASSEMBLY
Continued
FILLING OIL TANK
1. Remove oil cap.
2. Fill oil tank with SAE #30 motor oil.
Note: For temperatures below -1 °C,
use SAE #10 oil. For temperatures
above 24
°C, use SAE #40 oil.
3. Replace oil cap at once. Tighten oil cap
firmly for good seal. This will avoid oil
seepage from tank.
4. Wipe off excess oil.
Note: It is normal for oil to seep when saw
is not in use. Empty oil tank after each use to
prevent seepage.