Prior to startup, Setting the operating temperature, Min. = lowest cooling setting – Beko RBI 6301 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
en
en
Prior to startup
Before you begin operating your device, the
following points should be re-checked for
safety:
• Is the device standing properly on the floor?
• Is there sufficient space for good air
circulation?
• Is the interior clean? (Also see the section
“Cleaning and care”)
• Set the thermostat knob half way between
1 and 5 or Min. and Max.
• Now connect the device to the mains.
The compressor is turned on; the interior light
comes on when the door is opened.
Do not place foodstuff into the refrigerator until
the temperature has reached the desired level.
Setting the operating
temperature
(Fig. 2)
The operating temperature is regulated by the
temperature control.
The average temperature inside the fridge
should be around +5°C.
Please choose the setting according to the
desired temperature.
You can stop operation of your device by
adjusting the thermostat knob to “0” position.
Please note that there will be different
temperatures in the cooling area.
The coldest region is immediately above the
vegetable compartment.
The interior temperature also depends on
ambient temperature, the frequency with which
the door is opened and the amount of foods
kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended to close
the door again as soon as possible after use.
Warm
Cold
1
2
3
4
5
(Or) Min.
Max.
1 = Lowest cooling setting (Warmest setting)
5 = Highest cooling setting (Coldest setting)
(Or)
Min. = Lowest cooling setting
(Warmest setting)
Max. = Highest cooling setting
(Coldest setting)