Desa EFS33NR EN - Manual (Page 17)

107172-01J
17
17
For more information, visit www.desatech.com For more information, visit www.desatech.com
Shutting Off Heater
1. Turn control knob clockwise to the OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional Hand-Held Remote: Set selector switch in
the OFF position to keep from draining battery.
Shutting Off Burners Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing one
of the following:
• Turn control knob clockwise to the PILOT position.
• Use remote control manual OFF button.
• Set selector switch in the OFF position.
Figure 34 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot Burner
Figure 33 - Pilot (Natural)
Pilot Burner
Ignitor
Electrode
TO TURN OFF GAS
TO APPLIANCE
OPERATING FIREPLACE
Continued
OPERATING FIREPLACE
Lighting Instructions (Cont.)
To Turn Off Gas To Appliance
Manual Lighting Procedure
Optional Hand-Held Remote Operation
1. Follow steps 1 through 6 under Lighting Instructions, page 16.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob. Now follow
steps 9 through 11, page 16.
MANUAL LIGHTING
PROCEDURE
OPTIONAL HAND-HELD
REMOTE OPERATION
Figure 35 - Setting the Selector Switch, Control Knob, and
Flame Adjustment Knob for Hand-Held Remote Operation
O
FF
PIL OT
O
N
LO
IH
ON
OFF
REMOTE
Selector Switch in Remote Position
(Optional Hand-Held Remote Control)
Flame Adjustment Knob
Control Knob in
On Position
NOTICE: You must light the pilot before using the
hand-held remote control unit. See
Lighting Instruc-
tions, page 16.
1. After lighting, let pilot flame burn for about one minute.
Turn control knob to ON position. Adjust flame adjustment
knob anywhere between HI and LO. Slide the selector switch
to the REMOTE position (see Figure 35).
Note: The burner
may light if hand-held remote was on when selector switch
was last turned off. You can now turn the burner on and off
with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch in the RE-
MOTE or ON position when the pilot is not lit. This will
drain the battery.
ON/OFF SERIES
(MODELS GHRCB AND CGHRCB)
Hold the control button on the hand-held remote until burner
turns on. Hold the control button again until burner turns off
(see Figure 36).
TO LOCK press both buttons on hand-held remote control until
light stops flashing. Hand-held remote control is now locked. If
the fire is on it will be turned off automatically. In the locked
state, the light will not light up when any button is pressed.
TO UNLOCK press both buttons together on hand-held remote
control until the light stops flashing. The hand-held remote is
now unlocked.
Note: All remote control accessories must be purchased sepa-
rately (see Accessories, pages 28 through 30 ). Follow instruc-
tions included with the remote control.
THERMOSTAT SERIES
(MODELS GHRCTB AND CGHRCTB)
The hand-held remote can be operated using either the manual
mode (MANU) or thermostatic mode (AUTO) (see Figure 37,
page 18). To select Fahrenheit/Centigrade mode display, care-
fully press the ˚C/˚F mode button with the end of a paper clip or
similar blunt object.
Figure 36 - On/Off Hand-Held Remote Control Unit (C)GHRCB
Control Button
Turns Burners
On and Off