Digi W R 2 1 User Manual
Page 15
Digi TransPort® WR21 Installation Guide
Page 15
To stop the DHCP server from serving addresses, use the following command:
Command
Description
DHCP 0 IPMIN X
Removes the minimum IP address that will be server via
DHCP, disabling the DHCP server
As an example, to stop the DHCP sever from DHCP requests, enter the command
DHCP 0 IPMIN !. The !
variable is used to remove a value or set it back to its default.
To retain the DHCP server, but on a different subnet, the following parameters will need to be configured:
Command
Description
DHCP 0 IPMIN x.x.x.x
Minimum IP address to assign, the start of the DHCP pool
DHCP 0 IPRANGE
The number of IP addresses in the DHCP pool
DHCP 0 GATEWAY x.x.x.x
The IP gateway address the DHCP clients should use
(normally this router’s LAN IP address)
DHCP 0 MASK x.x.x.x
The subnet mask DHCP clients should use
DHCP 0 DNS
The DNS server DHCP clients should use
For more information on CLI commands, visit http://wwwreference
manuals available.