3DLABS Oxygen RPM - Manual (Page 12)

Installing Hardware
4 3Dlabs Oxygen RPM User’s Guide
3. Determine which slot you are going to use and remove its back panel
cover. You must use an AGP slot: AGP cards will not fit in PCI slots.
4. Attach the anti-static strap to your wrist, and attach the other end to a
conductive metal (not painted or sticker-covered) area of your system’s
chassis.
5. Remove the card from its anti-static packaging. Write down the serial
number for registration and future use.
6. Place the card into the AGP slot, and seat it firmly. See your system
documentation for instructions on securing the card to the chassis. Loose
cards and connections can cause grounding and operating problems.
7. Remove the anti-static strap and replace the cover on your system.