Desa (V)T32N-A Series - Manual (Page 23)

23
23
www.desatech.com 116646-01A
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Installing Optional Brick Liner Model BL32D (Cont.)
Installing Logs, Lava Rock and Glowing Embers
Figure 44 - Installing Side Brick Panels
Left Side
Brick Panel
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs sup-
plied with fireplace.
Open louvers, remove screen, unlock door latches and open glass
door. See steps 1 and 2 of Removing Glass Door, page 22. Install
logs according to instructions for fireplace model numbers.
1. Place log #1 (rear log) on top of grate. Make sure the notches
in the bottom of the log fit over the grate (see Figure 45).
1
Figure 45 - Installing Log No. 1
2
2. Rest log #2 (large front log) on the pins on the front part of the
grate (see Figure 46).
3. Place log #3 (crossover log) onto the rear and front logs. Make
sure it is seated properly on the smooth surface on the front log
and on the pin on the back log as shown in Figure 47.
4. Place log #4 (right log) on the pin on the right side of front log
as shown in Figure 48.
Figure 46 - Installing Log No. 2
4
Figure 48 - Installing Log No. 4
3
Figure 47 - Installing Log No. 3