ADLINK PCI-7396 - Manual (Page 58)

50
• Appendix 1 DIN-96DI
Legend:
CN1 : SCSI II 100 pin connector to connect PCI-7396 and DIN-96DI
X1~X4 : 50 pin Opto-22 connectors to connect TB96 and Tb96DI
n(1~96) : Input signal n
G : External ground
P : External power (5~24V)
A1.5 DI Circuits and Wiring
The outputs of the opto-isolated digital input circuits are open collector
transistors. PCI-7396 should provide pull-high resistors by correct jumper
setting. The connection between outside signal and PCI-7396 as well as the
jumper setting are shown below.
2.4K Ohm
Power 24V
Input
PCI-7396
DIn
Figure A1.1: opto-isolated input circuit
PCI-7396
DIn
JPxx
Vcc
GND
TTL Device
Figure A1.2: PCI-7396 jumper setting for DIN-96DI