ADLINK cPCI-6870 - Manual (Page 107)

IPMI User Guide 93
cPCI-6870
Sensor Device Commands
Get Device SDR
Info
35.2 S/E 20h
This command returns general
information about the collection of
sensors in a Dynamic Sensor Device.
Get Device SDR 35.3 S/E 21h
The ‘Get Device SDR’ command allows
SDR information for sensors for a Sensor
Device (typically implemented
in a satellite management controller) to
be returned.
Reserve Device
SDR Repository
35.4 S/E 22h
This command is used to obtain a
Reservation ID.
Set Sensor
Hysteresis
35.6 S/E 24h
This command provides a mechanism for
setting the hysteresis values associated
with the thresholds of a sensor
that has threshold based event
generation.
Get Sensor
Hysteresis
35.7 S/E 25h
This command retrieves the present
hysteresis values for the specified
sensor.
Set Sensor
Threshold
35.8 S/E 26h
This command is used to set the
specified threshold for the given sensor.
Get Sensor
Threshold
35.9 S/E 27h
This command retrieves the threshold for
the given sensor.
Set Sensor Event
Enable
35.10 S/E 28h
This command provides the ability to
disable or enable Event Message
Generation for individual sensor events.
The command is also used to enable or
disable sensors in their entirety using the
disable scanning bit.
Get Sensor Event
Enable
35.11 S/E 29h
This command returns the enabled/
disabled state for Event Message
Generation from the selected sensor. The
command also returns the enabled/
disabled state for scanning on the sensor.
Get Sensor Event
Status
35.13 S/E 2Bh
The Get Sensor Event Status command
is provided to support systems where
sensor polling is used in addition to, or
instead of, Event Messages for event
detection.
Command
IPMI
Spec
NetFn CMD Description