ADLINK MIX-110 - Manual (Page 26)

14 Getting Started
2.4 System Memory
The MIX-110 supports up to 4GB single channel DDR3
1066/800MHz SDRAM in two 204-pin SO-DIMM sockets.
Memory Module Installation
The DDR3 memory modules are notched to facilitate correct
installation in the DIMM sockets.
To install a memory module:
1. Remove both SATA drive brackets as described above
in “SATA Drive Removal” on page 11.
2. Locate the SO-DIMM slots on the motherboard.
3. Align the memory module on the socket, making sure
that the notch matches the break on the socket.
WARNING:
Disconnect all power supply to the board before installing a
memory module to prevent damaging the board and mem-
ory module.
Retaining clip
DDR3 DIMM notch