ADLINK RuffSystem 800 - Manual (Page 14)

RuffSystem Setup
10 User’s Guide RuffSystem
Applying Power to the RuffSystem
8) Follow these steps to apply
power to the RuffSystem. • Connect the AC Mating cable to the AC Adapter (options.) See
Figure 1 on page 5 .
• Plug in the DC Cable Connector from the AC Adapter to the DC IN
jack on the RuffSystem. See
Figure 3 on page 8 .
NOTE Power supplied to the unit must be within the allowed range
depending on the model of the unit:
• +12VDC to +25VDC for RUFxxx models
• +14VDC to +32VDC for RUFxxxW models
Failure to provide proper power may damage the system
and void the warranty.
• Plug in the CRT monitor’s power cord to an AC outlet, and turn on
the monitor.
• Plug in the AC Mating Cable to an AC outlet.
• Press the RuffSystem Power Switch* to the On position.
NOTE *The Power Switch on the LittleBoard 800 RuffSystem is a
momentary switch. Press and momentarily hold this switch
(
≈ 1 second) to power-on the RuffSystem.
9) Verify the RuffSystem
satisfactorily powers on. • To enter the BIOS Setup, press the <Del> key during power-on self
test (POST).
Use BIOS Setup during the initial boot to set the desired options.
• You should see POST complete successfully before the system
starts loading the operating system (optional.) If you are using
Linux, the boot loader will appear first, similar to the one shown
below with the optional OS name displayed.
NOTE The optional 2 ½" hard disk drive comes with partitions for
the OS and swap space.
ET1 E THERN ET 2
USB 4
USB 3
VG A
KYB D/MS
RESE T DC IN AU DIO
Rd
yS
y2
U_
24
a
GNU GRUB version 0.95 (632k lower/250768 upper memory)
Linux Kernel 2.6.x-xxx (recovery mode)
Use the and keys to select which entry is highlighted.
Press Enter to boot the selected OS, ‘e’ to edit the
commands before booting, ‘a’ to modify the kernel
arguments before booting, or ‘c’ for a command-line.
(The Linux 2.6 OS is shown as an example.)
S
y
s Linux_Boot_a