AMT Datasouth Fastmark 400 - Manual (Page 48)

User's Guide 47
Cleaning the Platen Roller
It is recommended that the platen roller should be cleaned when:
Excessive dusty condition exists.
Following a media jam where the adhesive comes in contact with it.
1. Turn off the printer and open the top cover.
2. Lift the printhead module to the vertical position.
3. Rub the full length of the platen available with a piece of cotton, which has been moistened
with Isopropyl Alcohol.
4. Manually rotate the platen and repeat step 3 until the entire platen has been cleaned.
Figure 18 - Platen Roller
Note: The roller should be cleaned whenever it has been in contact with foreign materials such as
dust or adhesives.
Platen Roller