AMT Datasouth Journey II - Manual (Page 100)

90
Printer Calibration - Error Messages Description and Corrective Action
Off line: Error: POST-MAG
Press RESET to Continue
This message indicates an error
occurred, in the ZONE 1 Post-Magnetic
Sensor (POST-MAG), during the sensor
calibration procedure.
This error can occur when:
•
Media dust or debris obstructs the
Post-Magnetic Sensor.
•
The Post-Magnetic Sensor cable fails
or is not connected properly.
•
The Post-Magnetic Sensor fails.
•
A component fails on the Main
Controller PCB.
To correct this error:
1. Perform the cleaning procedures and
vacuum out all media dust and debris.
2. If this error continues, power the unit
off and check internal cable
connections