AMT Datasouth Performax - Manual (Page 25)

15. Remove any slack from the
ribbon by turning the ribbon
advance knob in the direction
of the arrow marked on the ribbon
cartridge.
16. Replace the tear bar. Make sure power is ON before closing the rear cover.
17. The following message should Ribbon Replaced?
appear in the Y=Setup N=On Line display.
18. Press Setup key to reset ribbon usage value. Refer to Appendix E for additional
information on Ribbon Life Monitor.
NOTE
Make sure to reset Ribbon Life Monitor each time a new ribbon is installed.
Refer to Appendix E for information on Ribbon Life Monitor.
1-12
Loading Forms