AMT Datasouth Performax - Manual (Page 44)

4. Run the printer self-test (Maintenance Troubleshooting section).
5. Inspect the print sample. The characters should be easily read with no missing dots. Make
certain you check the last copy of multi-part forms for properly formed characters.
6. If the print quality is unacceptable,
move the print- head closer by one
detent position and run another print
sample (step 4).
NOTE
There is not a direct correlation between detent position and the number
of parts in a multi-part form (e.g. the adjustment control is not set to the
fourth mark for a four-part form).
7. Repeat this procedure until acceptable print quality is obtained.
2-13
Changing From Continuous Forms to Cut Sheets