Datamax E-4203 - Manual (Page 22)

12 E-4203/E-4204/E-4304
2. Use a finger to move the Bottom Slide until your selected Reference
Letter appears in the Setting Window of the slide.
3. Use a finger to move the Top Slide until your selected Reference
Letter appears in the Setting Window of the slide.
; Note: The Top and Bottom Slides must be positioned over the same
Reference Letter for proper media sensor function.
4. Proceed to ‘Loading Media’ (Section 3.3).
3.3 Loading Media
Load media into the printer as follows:
1. With the Cover open and
the Printhead Carrier
Assembly raised, remove
the Media Hub and insert it
through the Roll Media
(with the labels spilling
forward).
2. Place the Media Hub Flange
(with its smooth side toward
the media) onto the Media
Hub.
3. Place the Media Hub,
flange, and media onto the
Standoffs in the printer.
4. Route the media through the
printer, as shown below.
Roll
Media
Printhead
Latch
Printhead
Carrier Media
Hub
Media Hub Flange
(smooth side toward media)
Standoff