6 calibration mode – button functions – Datamax E-4203 User Manual
Page 44
34
E-4203/E-4204/E-4304
4.6 Calibration Mode – Button Functions
In ‘Calibration’ mode, the buttons allow the printer to adjust to the media
being used. Calibration can be performed either automatically or
manually, as detailed below.
;
Notes: Before calibrating, ensure that the Printhead Carrier Assembly is
latched down, that the cover is closed, and that the media sensor has
been set for the appropriate media type, see Section 4.4.2.
Printer and cutter faults are disabled during
and
, but can still occur while printing “test” labels.
If at any time you wish to discard your changes and revert back to the
previous calibration simply turn off power to the printer. Also, Factory
Defaults can be restored, see Section 5.7
To perform Calibration:
F1
Auto Media Calibration (See Section 4.6.1)
(See Section 4.6.2)
Calibration Mode
F3
Analyze media
F3
F2 Analyze media backing material or reflective mark
Analyze no media condition
F1
Feeds one label for “test”
F2
Press and hold until the
Paused Light turns on
Press and
Release
F2
F3 Prints the ‘Test Label’ for “test”
F1
F3
+
Saves the current values
and resumes
Normal Mode
F1
F3
+
Accepts the current
analysis for “test”
Media Sensor Calibration
(
)
(
)
(Press and hold during power-up until the Paused Light turns off)
(The Fault Indicator flashes during analysis)