Easyrig 5 Vario - Manual (Page 7)

7
Fig. 8
Make sure your Easyrig vario 5 feels
comfortable and that the support arm is in a
good vertical position, not too high or too low.
Fig. 10
Adjust the height of the support arm by
removing the Easyrig vario 5 cover located on
the back of your Easyrig vario 5. Locate the two
cover screws and unscrew them with the 6mm
Allen-key to remove the cover.
Fig. 11
Using the same 6mm Allen-key, locate and
loosen the four adjustment screws on the
Easyrig vario 5 mechanism.
Fig. 9
Leave a gap of approximately 2-15 cm (1-6
inches) between the top of the camera hook and
the support arm.
• If there is a need for adjustment, continue to
step 10 or 12b.
• If everything is correct, continue to step 13.
10
11
8
9
13