Echelon LNS - Manual (Page 362)

LNS Programmer's Guide 348
1. Close the monitor and control application, and launch the
network management application from the client PC.
2. Select Remote Lightweight Client as the Client Type
option.
3. Type in the network name
4. The Network Path textbox will turn into Server IP
address and port and will be enabled. Enter this
information using the following format: <lns://
xxx.xxx.xxx.xxx:2540/>.
5. Click Manage.
6. Close the network management application. Then, restart the
monitor and control application and continue with step 2
below.
Table C.3 lists where you can find source code information for each
possible selection:
Table C.3 Source Code Information
Selection For Source Code Information, See….
Local Client CLcaMonitorDlg::OnSelectLocalClient() in the
LcaMonitorDlg.cpp file.
Remote Client
Using Networks
Collection
CLcaMonitorDlg::OnSelectFullClientUseNetworksCol()in the
LcaMonitorDlg.cpp file.
Remote Client
Using Remote
Networks
Collection
CLcaMonitorDlg::OnSelectFullClientUseRemoteNetworksCol()
in the LcaMonitorDlg.cpp file.
Remote
Lightweight Client
CLcaMonitorDlg::OnSelectLightWeightClient() in the
LcaMonitorDlg.cpp file.
Server
Independent Client
CLcaMonitorDlg::OnSelectIndependentClient() in the
LcaMonitorDlg.cpp file.
2. Select a network interface from the Network Interface drop-down box.
Typically, this should be the network interface that the LNS Server PC is
using. With certain client types, this option will be selected for you. (i.e.
Remote Lightweight Client).
For source code information, see
CLcaMonitorDlg::OnSelchangeNetworkInterfaceName() in the
LcaMonitorDlg.cpp file.
3. Select a network created with the example network management
application from the Network Name drop-down box. This lists the