Elenco Deluxe Snap Rover&reg - Manual (Page 17)

-16-
OBJECTIVE: To make exciting sounds.
Space Sounds Project #7
OBJECTIVE: To make an electronic recording and play it back.
Audio Recorder Project #8
Build the circuit with the base grid
centered on the Rover body, and
connect the jumper wires as shown.
Turn on the right slide switch (S1).
Turn the knobs on the sound &
recording IC (U9) to make a variety of
space sounds.
R
O
VER REAR
Build the circuit with the base grid centered
on the Rover body, and connect the jumper
wires as shown. Turn off the left slide switch
(S1) and turn on the right slide switch.
Turn on the left slide switch and talk into the
microphone to make a recording; turn off
the left switch when finished. The red light
on U9 will be on while you record, it goes
out when you finish or when the memory is
full. Your recording can be up to 12 seconds
long.
Push the press switch (S2) to play your
recording.
R
O
VER REAR
Push to play
recording
On/Off
Microphone
Keep OFF. Slide
to ON to record
message, then
slide back to OFF.