Elenco Deluxe Snap Rover&reg - Manual (Page 22)

-21-
C
h
a
n
n
e
l
s
w
itc
h o
n remote
co
n
tr
o
l
u
n
it.
Project #18
OBJECTIVE: To build a remote control vehicle.
Remote Drive Rover
Move the end of the red jumper wire that is at the location marked to
the location marked (on RX2). Now the white LED is controlled by
the right button on the remote control unit.
Project #17 Nightlite Rover
Build the circuit (being sure to connect all
eight colored jumper wires), and turn on
the right slide switch (S1). Use the levers
on the remote control unit to drive Rover
around. The white LED (D4) in front acts
as a headlight, so you can use it in a dark
room.
If the left slide switch is off then you will
hear a tone. Turn the knobs on the sound
& recording IC (U9) to change the tone.
Press the left button on the remote control
to play the recorded message. Push the
press switch (S2) and talk into the
microphone on U9 (sound & recording IC)
to change the recording.
OBJECTIVE: To drive around in the dark.
R
O
VER REAR
+
B
A
A
B