Elenco Deluxe Digital / Analog Trainer with Tools Kit Version - Manual (Page 10)

-9-
MOUNTING THE PC BOARD
Note: The holes in the two side panels have been punched differently. Be sure that you have the correct side
panel when mounting them to the PC board.
IMPORTANT: Push the PC board up as far as possible before tightening the screws, as shown in Figure O.
r Mount the PC board to the side panels with four 4-40 x 1/4” screws (see Figure N).
Do not tighten the screws.
r Place the top panel onto the unit and align the components with the holes in the top panel. Push the PC
board up until the components come through the top panel and tighten the screws.
Figure O
Figure N
4-40 x 1/4” screws
Top legend side of PC board
Note: From the foil side of the PC
board, inspect the edges to be sure that
there are no component leads shorting
against the side panels.
Adjust the PC board
height with a 4-40 x
1/4” screw
4-40 x 1/4” screws