Elenco Deluxe Digital / Analog Trainer with Tools Kit Version - Manual (Page 7)

Figure G
Diodes have polarity. Mount them
with the band as shown on the top
legend.
-6-
INSTALL COMPONENTS TO PC BOARD
R1 - 120
W
5% 1/4W resistor
(brown-red-brown-gold)
J28 - Jumper wire
(see Figure F)
J6 - Jumper wire
(see Figure F)
D12 - 1N4001 diode
D11 - 1N4001 diode
(see Figure G)
C14 - 100
m
F 25V lytic
C17 - 100
m
F 25V lytic
(see Figure E)
R2 - 120
W
5% 1/4W resistor
(brown-red-brown-gold)
J2 - Jumper wire
(see Figure F)
J3 - Jumper wire
(see Figure F)
Figure F
Cut a piece of the #22 bare wire
long enough so that 1/4” of wire
passes through each hole in the
PC board after the wire is formed.
Band
Bottom left corner of PC board
Figure E
These capacitors are polarized.
Be sure to mount them with the “+”
lead in the correct hole as marked
on the PC board. Mount the
capacitor lying flat on the PC board
as shown below.
Warning: If the capacitor is connected with
incorrect polarity, it may heat up and either leak
or cause the capacitor to explode.
(+) (–)
Start Here