Elenco Deluxe Digital / Analog Trainer with Tools Kit Version - Manual (Page 21)

Figure DD
FINAL ASSEMBLY
If you are immediately going to build the remaining sections, do not continue with the instructions on
this page and proceed to page 22.
r Fasten the front panel in
place with four #6 x 3/8”
thread cutting screws, as
shown in Figure BB.
r Fasten the PC board to the
spacer on the front panel
with a fiber washer and a
4-40 x 1/4” screw (from
Power Supply Section)
from the foil side of the PC
board, in the location
shown in Figure CC.
r Fasten the pots to the front
panel with an 8mm washer
and a 7mm nut, as shown
in Figure BB.
r Turn the shafts on the two
switches fully counter-clock-
wise. Push the knobs onto
the shafts so that the line on
the knob is in line with the
end of the circle on the front
panel (see Figure DD). If the
knob is loose on the shaft,
insert a screwdriver into the
slot and expand the slot
slightly (see Figure EE).
-20-
Figure CC
4-40 x 1/4” Screw
Figure EE
Knobs
Nuts 7mm
Nuts 7mm
Washers 8mm
Washers 8mm
#6 x 3/8” Thread
Cutting Screws
#6 x 3/8” Thread
Cutting Screws
Figure BB
Fiber Washer