ENMET PGD2 - Manual (Page 22)

ENMET Corporation PGD2
19
8.3 Examples of standard ENMET Calibration Gas & Accessories
Part number Description
03296-209 Gas Cylinder, Clean Air/Zero Gas, 20.9% oxygen in nitrogen
03220-050 Gas Cylinder, 25% by vol/50%LEL methane/CH
4
in nitrogen
03220-199 Gas Cylinder, 100% by vol methane/CH
4
03314-020 Gas Cylinder, 20ppm H
2
S in air
03223-2000 Gas Cylinder, 2000 ppm CO
2
in air
03302-010 Gas Cylinder, 10 ppm HCL in air
03331-010 Gas Cylinder, 10 ppm CL
2
in air
02506-002 Cylinder Regulator
02506-004 Cylinder Regulator
03700-041 Calibration Adapter, Stainless Steel
03700-046 Calibration Adapter, PTFE
03700-048 Sampling Adapter, Stainless Steel
03700-050 Sampling Adapter, PTFE
9 B ATTERY C HARGING E QUIPMENT
Warning: Equipment used for charging of the Portable Gas Detector battery must be located in a safe area i.e. in an
atmosphere where it is known that there is no risk of the presence of combustible gas.
The PGD2 instrument is fitted with a rechargeable battery pack. There are a number of different purpose designed chargers which can
be used and these are detailed later in this section. Improvements to the battery charging equipment have been made over the lifetime
of the product and so earlier equipment which is no longer manufactured is not listed below.
The battery module can either be charged: -
a) within the instrument without removal from it’s protective boot using the equipment detailed in the following sections.
or,
b)
separately when removed from the instrument using the equipment detailed in Section 9.5.
List of recommended chargers.
Description Type
‘Smart’ Charger PGDC2
Charger Interface Unit PGDC2/I
Vehicle Mounted ‘Smart’ Charger PGDC3
Compact Charger PGDC4
5-Way Charger PGDC5
Multi-volt Charger PGDC6
Note – The Compact Charger is the standard charger that is supplied with each new instrument unless otherwise requested.