Denon DVD-1800BD - Manual (Page 11)

7
Introduction Introduction
ENGLISH
ENGLISH
The unit can also be turned on by pressing the buttons with circled numbers.
Part Names and Functions
Front Panel
7 8 9 10
4 5 6 3 2 1
1. Power indicator
This indicator lights up in red in standby
mode and turns off when the power is on.
2. ON/STANDBY button
Press to turn the unit on or to standby.
3. OPEN/CLOSE A button
Press to open or close the disc tray.
4. PLAY B button
Press to start or resume playback.
5. STOP C button
Press to stop playback.
6. PAUSE F button
Press to pause playback.
7. SD CARD slot
Insert an SD Memory Card, and play back the
contents in it.
8. Infrared sensor window
Receives signals from your remote control so
that you can control the unit from a distance.
9. Display
Refer to “Front Panel Display” on page 9.
10. Disc tray
Place a disc when opening the disc tray.
Rear Panel
2 1 3 4 5 6
1. VIDEO OUT jack
Use an RCA video cable to connect to a TV
monitor, AV receiver or other device.
2. COMPONENT VIDEO OUT jacks
Use a component video cable to connect to
a display device with component input jacks.
3. HDMI OUT jack
Use an HDMI cable to connect to a display
with an HDMI input jack.
4. AUDIO OUT jacks
Use an RCA audio cable to connect these
jacks to the audio input jacks of your
amplifier with input terminals.
5. DIGITAL OUT (COAXIAL) jack
Use digital audio coaxial cable to connect to
an AV receiver, Dolby Digital decoder or
other device with a digital audio coaxial
input jack.
6. AC IN Terminal
Use to connect the AC cord to supply the
power.
Note
• Do not touch the inner pins of the jacks on
the rear panel. Electrostatic discharge may
cause permanent damage to the unit.
E5H60UD_EN.book Page 7 Thursday, August 21, 2008 1:54 PM