ENMET EX-5175-EC - Manual (Page 14)

EX-5175-EC ENMET Corporation
12
6.0 Replacement Part Numbers
ENMET replacement part numbers:
Description Part Number
For EX-5175-EC p/n
Sensor: Oxygen
Carbon Monoxide
Hydrogen Sulfide
Ammonia
Sulfur Dioxide
67027-1100
67027-1200
67027-0200
67027-2400
67027-0500
Consult ENMET Distributor or ENMET Corp for additional sensors
Regulator Assembly, for 34/58/103l cylinders 02506-002
Magnet 50030-001
Calibration/Sampling Adapter 03700-034
Regulator Assembly, for 17/34l cylinders 02506-004
Calibration Gas, Consult ENMET Distributor or ENMET Corp.
7.0 WARRANTY
ENMET warrants new instruments to be free from defects in workmanship and material under normal use for a period of one
year from date of shipment from ENMET . The warranty covers both parts and labor excluding instrument calibration and
expendable parts such as calibration gas, filters, batteries, etc... Equipment believed to be defective should be returned to
ENMET within the warranty period (transportation prepaid) for inspection. If the evaluation by ENMET confirms that the
product is defective, it will be repaired or replaced at no charge, within the stated limitations, and returned prepaid to any
location in the United States by the most economical means, e.g. Surface UPS/FedEx Ground. If an expedient means of
transportation is requested during the warranty period, the customer is responsible for the difference between the most
economical means and the expedient mode.
ENMET shall not be liable for any loss or damage caused by the improper use of
the product. The purchaser indemnifies and saves harmless the company with respect to any loss or damages that may arise
through the use by the purchaser or others of this equipment.
This warranty is expressly given in lieu of all other warranties, either expressed or implied, including that of merchantability,
and all other obligations or liabilities of
ENMET which may arise in connection with this equipment. ENMET neither assumes
nor authorizes any representative or other person to assume for it any obligation or liability other than that which is set forth
herein.
NOTE: When returning an instrument to the factory for service:
Be sure to include paperwork.
A purchase order, return address and telephone number will assist in the expedient repair and return of your unit.
Include any specific instructions.
For warranty service, include date of purchase
If you require an estimate, please contact ENMET Corporation.
There are Return for Repair Instructions and Form on the last pages of this manual. This Form can be copied or used as needed.
Manual Part Number
80003-099
January 2008
MCN-418, 04/16/09
MCN-447, 05/24/11
MCN-459, 12/13/11