Eurocom D900T PHANTOM - Manual (Page 67)

Drivers & Utilities
ATA Mode Configuration 4 - 3
4
ATA Mode Setup
1. Prepare a formatted blank 3.5" 1.44MB floppy diskette, and an external USB floppy disk drive.
2. Create an ATA Driver Diskette by using an operable computer to copy the Drivers\RAID\ATA folder
from the Device Drivers & Utilities + User’s Manual CD-ROM (Navigate/Browse.. to
D:Drivers\RAID\ATA) to the blank floppy diskette.
3. Connect the external USB floppy disk drive to the notebook computer.
4. Startup your computer and press <F2> to enter the BIOS (see “The Setup Program” on page 5 - 4 ).
5. Set the RAID/ATA Mode Select to ATA Mode (see “RAID/ATA Mode Select: (Advanced Menu)” on
page 5 - 10 ).
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Exit
F1 Help Select Item -/+ Change Values F9 Setup Defaults
Esc Exit Select Menu Enter Select Sub-Menu F10 Save and Exit
Item Specific Help
Setup Warning
Setting items on this menu to incorrect
values may cause your system to malfunction.
System Information
I/O Device Configuration
Reset Configuration Data: [No]
Hyper Threading Technology: [Enabled]
Power On Beep [Disabled]
Card Reader : [Enabled]
RAID/ATA Mode Select [ATA Mode]
Advanced
Figure 4 - 1
BIOS Advanced
Menu