EXFO FastReporter Data Post-Processing Software - Manual (Page 153)

Viewing and Editing Measurements
Data Post-Processing Software 147
Viewing and Editing Measurement Identification Information
Modifying Start, Stop, and Step Values
You can modify the Start, Stop, and Step values of the iOLM configuration
file.
To modify the Start, Stop, and Step values:
1. Open an iOLM configuration file.
2. Select the configuration for which you want to modify the Start, Stop,
and Step values. You can select more than one using the Ctrl or Shift
keys.
3. In the Results window, select the Identification tab.
4. Enable the Auto-Increment option to modify the Start, Stop, and Step
values.
5. Enter the Start, Stop, and Step values for the identifiers.
Note: The Step value must be smaller than the difference between the Start and
Stop values. If the Start is greater than the Stop, then the identifier value
begins decrementing by the specified Step.