EXFO BV10 Performance Endpoint Unit - Manual (Page 76)

CLI Command Reference
70 BV10
Configuration Commands
Test Application Commands
smart-loopback enable|disable
Description Enables or disables the Smart Loopback application. Smart Loopback is
enabled by default.
This command acts on the Smart Loopback application only; it is not a
global switch for all test applications. For example, if Smart Loopback is
disabled but TWAMP Light is enabled, TWAMP packets continue to be
reflected.
Refer to Smart Loopback Test on page 74 for more information.
Syntax smart-loopback enable|disable
Example bv10-100> smart-loopback disable
smart-loopback disable
smart-loopback mode ethernet-all-unicast|ethernet|ip|udp-tcp
Description Sets the Smart Loopback feature to one of the following modes:

Ethernet All Unicast

Ethernet

IP

UDP/TCP (default)
Refer to Smart Loopback Test on page 74 for more information.
Syntax smart-loopback mode
ethernet-all-unicast|ethernet|ip|udp-tcp
Example bv10-100> smart-loopback mode udp-tcp
smart-loopback mode udp-tcp
bv10-100> smart-loopback mode ethernet
smart-loopback mode ethernet