5 flat surface installation - vertical collector – Glow-worm Clearly Solar - A-Frame User Manual
Page 14
Advertising
14
Diagram 5.8
15404
CLAMPING
ASSEMBLY
COLLECTOR
LOWER EDGE
Place the collector with the lower edge in the section of the
mounting rail, see diagram 5.8.
Make sure that the upper part of the clamping assembly is
above the collector edge.
Slide the upper mounting rail until it is flush with the collector.
Make sure that the upper part of the clamping assembly is
above the collector edge, see diagram 5.9.
Tighten the lower clamping assemblies with the socket/
combination wrench (SW13).
5 Flat Surface Installation - Vertical Collector
Diagram 5.9
15001
CLAMPING
ASSEMBLY
COLLECTOR
EDGE
LOWER
MOUNTING
RAIL
UPPER
MOUNTING
RAIL
Advertising