Glow-worm Clearly Solar Horizontal In-Roof Collector - Manual (Page 27)

27
7.2 Support plates
Fix the top batten into position as shown in diagram 7.13.
Mount the support plates above the collector:
- one on the external edge (max. 150mm from the edge)
- one per collector joint (central).
Make sure that the support plates are on the collector frame
slot, see diagram 7.14.
Fix the support plates to the top roof batten with two screws
(No. 3) using the supplied Torx bit.
Slide the boards through the support plates.
Fix the boards to the support plates with two screws (No. 2)
using the supplied Torx bit, see diagram 7.14.
Slide the ridge plate extension on the support plates, see
diagram 7.15. Make sure that the ridge plates are above the
side sections.
Fix the ridge plates to the roof battens with the screws (No. 1)
using the supplied Torx bit.
Fix the ridge plate coupling to the ridge plate joint with three
screws (No. 5) using the supplied Torx bit, see diagram 7.16.
7 One Collector Extension Kit - 22 0 - 75 0
15029
Diagram 7.14
15123
max 150
1066
1066
COLLECTOR FRAME
SLOT
SCREWS
(No.3)
SCREWS
(No.2)
Diagram 7.15
15149
RIDGE PLATE
SCREWS
(No.1)
Diagram 7.16
15150
No.5
RIDGE PLATE
COUPLING
SUPPORT
PLATES
Diagram 7.13
15308
350mm
TOP
BATTEN