Go Power! GP-600 - Manual (Page 3)

1. Introduction
The Go Power! Inverter series provides mobile power for people on the go. Run
standard AC appliances wherever you travel. Silent, lightweight and simple to
use, Go Power! Inverters can be used in a wide range of applications including
remote homes, RVs, boats and long haul trucks. It will operate most televisions and
VCR’s, personal computers and small appliances including drills, sanders, grind-
ers, mixers, blenders and microwaves. The inverter must have a greater power
rating than the load to which it is providing power.
To get the most out of your power inverter, it must be installed and used properly.
Please read the instructions in this manual before installing and using
your inverter.
2. Specifications
2.1 GP-600 Inverter 12V
Output 600 W
Output wave form Modified Sine Wave
Output voltage 115 VAC rms
Regulation +5%-10%
DC input voltage 10-15 V
Low battery alarm ± 2% 10.5 V
Low battery shut-down ± 2% 10 V
Efficiency 80-90%
Frequency ±1% 60 Hz
No load current 0.2 A
Surge rating 860 W
Over thermal protection Yes
Cooling fan Yes - continuous
Overload protection Yes
Dimensions (LxWxH) 230 x 85 x 51 mm
9” x 3.4” x 2”
Net weight 2.1 kg
4.6 lbs
Inverter Install Kit Included
Go Power! Modified Sine Wave Inverter
Owner’s Manual
Go Power! Modified Sine Wave Inverter
Owner’s Manual
10 3
8. Maintenance
Very little maintenance is required to keep your inverter operating properly. You should
clean the exterior of the unit periodically with a dry cloth to prevent accumulation of
dust and dirt. At the same time, tighten the screws on the DC input terminals.
9. Warranty
We warrant this product against defects in materials and workmanship for a period of
12 months from the date of purchase and will repair or replace any defective Go
Power! Inverter when directly returned, postage prepaid, to the manufacturer. This
warranty will be considered void if the unit has suffered any obvious physical
damage or alteration either internally or externally, and does not cover damage arising
from improper use such as plugging the unit into an unsuitable power sources,
attempting to operate products with excessive power consumption requirements,
reverse polarity, or use in unsuitable climates.
This is the only warranty and the company makes no other warranties, express or
implied, including warranties of merchantability and fitness for a particular purpose.
Repair or replacement are your sole remedies and shall not be liable for damages,
whether direct, incidental, special or consequential, even though caused by negli-
gence or other fault.
Low battery alarm on all the
time, LED indicator is red. Low input voltage.
Poor DC wiring, poor
battery condition.
Have qualified service techni-
cian check and replace.
Make sure that inverter is
connected to 12 V battery.
Check regulation of charging
system.
Recharge battery. Use proper
cable and make solid connec-
tions. Use new battery.