4. preparing for tag printing, 5. connecting the printer to the host computer – GoDEX EZPi1000 series User Manual
Page 15
Advertising
EZPi1000 User Manual
11
2-4. Preparing for tag printing
In tag printing, the tag hole indicates the height
of a label. During adjustment, the sensor must
therefore be positioned directly below the tag
hole as shown in the illustration. The tag hole
should be at least 3 mm in diameter to ensure
correct functioning.
Sensor position
Sensor
2-5. Connecting the printer to the host computer
1.
Please make sure that the printer is switched off.
2.
Connect the power cord to the AC adapter and connect the adapter to the
printer.
3.
Connect the USB / parallel cable to the printer and host computer.
4.
Switch on the printer. The operator panel should now light up.
Advertising