GoDEX EZPi1000 series - Manual (Page 38)

EZPi1000 User Manual
34
4-3. Installing the WLAN module
1 Ethernet cable, 1.8 m
2 Fastening screw
3 Screws for Ethernet module (set of 2)
4 Bracket
5 WLAN module
6
Connection cable (module to
motherboard)
7 WLAN antenna
8 Nut
9 Washer
10 Fixing plate
11 Antenna bracket
12 SPRING LEAF 接地彈片
1. Make sure that the printer is switched off
and the power cord disconnected from the
printer. You should work on a clean, flat
surface.
Turn the printer upside down and remove
the two screws marked in the illustration
from the printer housing.
2. Place the printer the right way up again
and lift the printer cover.
3. To remove the top part of the printer
housing, gently pull the open printer cover
upwards.
4. Disconnect the connection cable from the
motherboard.