GoDEX EZ2250i series - Manual (Page 49)

45
5
Accessories
5.2 Installing the rewinder guide
1. Unscrew the screw marked in the
illustration on the front of the
printer, which secures the lower
cover plate.
2. Remove the lower cover plate.
【 Note 】
Switch off the printer before starting
the installation.
3. Mount the rewinder guide on the
print mechanism and secure it
with screws.
4. Installation of the rewinder guide
is now complete.
5. Now load the label stock.
6. Pass the label stock through the
rewinder from the bottom up.
Secure the label stock on the
rewinder using the retention clip.
【 Note 】
Make sure you choose the correct
rewind direction.
7. Close the printer cover to
complete the installation.
【 Note 1 】
Before you start using the rewinder,
please make sure that you have
carried out all the steps as shown in the
illustrations.
【 Note 2 】
To use the label dispenser, you have to
remove the rewinder guide again.