GoDEX EZ2250i series - Manual (Page 50)

46
5
Accessories
5.3 Label dispenser
1. Unscrew the screw
marked in the illustration
on the front of the
printer, which secures
the lower cover plate.
2. Remove the lower
cover plate.
【
Note
】
Switch off the printer before
starting the installation.
3. Place the printer the
right way up again.
4. Pull out the print head
release lever as shown
in the illustration (1) and
turn it anticlockwise to a
top right position (2).
5. Remove the retention
clip.
1
2
3
6. Now load the label roll
into the printer.
【
Note
】
A label liner thickness of 0.06
mm ± 10%, a weight of 65 g/
㎡
± 6% and a label height of
20 mm are recommended.
【 Suggestion 】
When using the label
dispenser, you should set the
stop position (^E) to 12.
7. Strip a few labels off the
label liner (approx. 400
mm). Then pass the
label liner through the
print mechanism and
from the bottom up
onto the rewinder.