Dream Vision DM 7000-S - Manual (Page 10)

5. General notes
5.1 Hifi amplifier
Check that everything has been delivered.
You should have received the following:
1 receiver
1 power cable
1 remote control
1 Instruction Manual
(latest version available from http://www.dream-multiedia-tv.de )
1 guarantee card
2 batteries (1.5V microcell)
2 hard disk installation frames (supplied within the unit from the factory)
1 IDE connection cable
1 power cable for the hard disk
Optionally available:
1 infrared keyboard
- Check the battery polarity carefully and install the batteries supplied in the
battery compartment of the remote control.
- Before you connect the receiver, please read the safety instructions under
point 6. Safety Instructions.
- Connect the external unit (dish, LNB) with an F plug to the LNB input on
the receiver.
- Connect the receiver with a Scart cable to your television (Scart socket
TV), and to a video recorder or DVD player (Scart socket VCR).
- Plug the mains cable into the receiver and then into a suitable 230V / 50Hz
power socket.
5.1.1 Analog
To connect your Dreambox to a hifi amplifier, please use a suitable phono
cable. Connect this to the receiver at AUDIO R/L and to a free input (e.g. AUX
or CD) on your hifi amplifier.
5.1.2 Digital
If your amplifier has a suitable optical input, connect the DIGITAL AUDIO
socket on the receiver to the optical input of the amplifier with an optical
cable. Sampling frequencies of 16, 22.05, 24, 32, 44.1 and 48 kHz are
available. This output also provides the Dolby Digital signal (AC3) when
this is broadcast.
10
5. Getting started
5. Getting started