Dream Vision DM 7000-S - Manual (Page 47)

17. Set-up TV control
17. Set-up TV control
47
A four-digit TV device code is selected from the TV model list in the table in
Chapter 18 and entered.
TV mode -> <<Set-up>> -> number -> number -> number -> number
17. Set-up TV control
4.1 Programming sequence
1. Briefly press the TV key once.
2. Press SHIFT/setup key for 3 seconds the TV key should blink twice.
3. Enter the TV code with the numeric keypad on the remote control.
Each number input is acknowledged by the TV key blinking once.
After the fourth digit has been input, a valid code is acknowledged by the TV
key blinking twice.
4. The remote control then automatically leaves programming mode.
5. If no code is input for 10 seconds, the remote control automatically leaves
programming mode.
Shift-/Setup-Funktion
TV-Steuerung
Zehnertastatur